Remove all of the retaining fasteners and then carefully pull up on the cowl.

Mar 08, Buy Now!New Windshield Wiper Transmission Linkage Bushing from takedownstump.bar takedownstump.bar Auto shows you how to repair, install, fix, change o.

Feb 18, My wife's car passenger side windshield wiper quit working on her, so I need to get this fixed for her. What I found was that the bushing for the passenger w. Sep 16, Mine are attached with a hex nut located beneath a plastic cover on the pivot end of the wiper arm. Just remove the nut, pull off any washer tubes from their fittings on the cowl or pivots, relieve the spring pressure holding the wiper onto its shaft, and pull it straight up and off.

Set the wipers aside in a safe place. Step 2: Remove the CowlEstimated Reading Time: 7 mins. Pop the hood and disassemble the rods and pivots. Pry up all of the plastic linkage bushings with a flat head screwdriver. Slide the screwdriver under the bushings and pull up. Throw all of the old bushings away. Lay out all of the new bushings and make sure there.

Push down on the tab and slide the connector off.

Nov 25, Not the full demonstration, but this will show the basics and give enough tips to make this job easy. Jan 22, How do you remove windshield wiper linking bushings? Pry up all of the plastic linkage bushings with a flat head screwdriver. Slide the screwdriver under the bushings and pull up. Throw all of the old bushings away. Lay out all of the new bushings and make sure there are three caps and one with a hole all the way through it.

Are wiper refills. Feb 25, How do you change windshield wiper bushings? How to Install Wiper Linkage Bushings. Pull the wipers straight out away from the windshield. Pull up the screen on the front of the windshield of the vehicle to access the wiper assembly. Pop the hood and disassemble the rods and pivots. Push the bushings into the rod holes with a pair of pliers.

Nov 08, Step 4: Remove the wiper arm retaining nut. Remove the wiper arm retaining nut using a ratchet, extension and socket of the appropriate size.

The easiest way to remove is by using a set of pick tools and or small needle nose pliers.

Step 5: Remove the wiper arm. Pull the wiper arm up and off the linkage stud. Note: In some cases, the wiper arm is pressed on and removal requires a dedicated wiper arm puller. Step 6: Raise the hood. I tried that-it does make it a lot easier. The second press (onto the shaft) is a bit tight but do-able, depending on your strength. It helps if you move the shaft back and forth a bit while pressing down on the bushing. It looks like the Dorman wiper linkage bushings fit on a wide variety of MoPar from '74 to ' My cost wasand tax.

the wiper motor controls the wipers via a linkage located below the windshield under the hood you may need to remove a the plastic cover to acess the assembly, one of the linkage arms has fallen off possibly due to a worn bushing on the end of the arm,just replace the bushing and reattach it.