Freedom Racing.

Use DT for /8" ID. Use J for /8" ID. Used to remove and install the rear output shaft bearing without removing and disassembling the transfer case. Once the driveshaft is removed, the tool is expanded into the bushing, and its forcing screw is tightened against the output shaft to remove the takedownstump.bar: SPX/Bosch (OTC Rotunda Kent-Moore Miller). REMOVER, OUTPUT/TURBINE SHAFT BUSHING. Essential.

J has been classified by Allison Transmission as an Essential Overhaul Tool servicing the following product lines: / Series; USDper unit. Qty: Continue Shopping. Feb 18, In this video I am going to show you how to remove the bushing in your transfer case output shaft. How to properly re install it and ream to the perfect siz. Feb 19, I'm getting ready to replace the output shaft bushing on my transfer case.

I have allot of play on the yoke so I'm going to replace the yoke and the bushing. I have replaced the rear seal 3 time in the last 3 or 4 months. I thought I was buying cheap seals so last one was a GM seal same thing. I finally figured out I must have a worn bushing Estimated Reading Time: 11 mins. Apr 30, Bloomington, MN. KD Tools makes a tool for this. (#) (Don't know if it's still available or not.

I got one burlingame tree removal permit ebay years ago.) You can use it to pull and replace the tail shaft bushing.

Makes it a 5 minute job. maverick said: place the tailshaft in a degree oven & the bushing in the freezerthe coefficient of thermal expansion is. Jun 14, The thing is, nobody actually makes a bushing for a T56 for whatever reason. There's one exception, but it's like 30 and in my opinion not even worth it because there's a chance it will end up jacked up on install, or slip, etc., and you're outDon't worry about the getting it out part, the getting one in part is the takedownstump.barted Reading Time: 11 mins.