Misc Mortising Equip.

Mar 30, You need to adjust the hinge to make is possible to roll down the tree. Start with sawing off the middle of the hinge so that two corners are saved. Then cut off the corner on the opposite side from the direction in which you intend to roll down the tree. Cut this corner with repeated saw cuts diagonally from takedownstump.barted Reading Time: 5 mins.

A bore can be used with most felling methods and can be applied regardless of guide bar length and tree size.

Rolling the tree method Slightly leaning hang-ups are usually easy to roll down. Use the turning hook or turning strap if you think that the tree is not too stuck. Here’s how to do it. STEP-BY-STEP 1. Asses the tree Assess the tree to decide in which way the tree can be rolled down. 2. Adjust the hinge You need to adjust the hinge to make is possible to. Oct 25, Part 2, how to deal with a tree that wont roll out.

Removing the remaining 20% of the hinge without standing in the danger zone, or getting your saw trapped. The repeated cuts move the snag or hung tree in a lateral direction, encouraging it to dislodge and keeping the snag from becoming more vertical where it is likely to fall unpredictably when it dislodges.

The controlled release hinge maximizes cutter control and safety. Bore cutting the back cut of the controlled hinge release.

Feb 12, When hinge cutting for deer habitat, we are often cutting in woods with very high stem density, so that trees sometimes get hung up. takedownstump.barEDEERHABITAT.C. 1. Assess which way the tree can be rolled down. Saw off the middle of the hinge so that two corners are saved. Next cut off one corner with repeated saw cuts diagonally from above.

Leave the corner on the side that you intend to roll down the tree. 2. Take the turning hook (turning strap) and roll the tree. Jan 19, Make the two backcuts, leaving plenty of hinge. With cable winch, pull just above the upper cuts, from a safe distance of course, and watch the tree drop.

Repeat a/r but only with the upper felling cuts until it's all on the ground. No need to add a pivot.

In some cases, it may be necessary to make two escape routes.

Hang-up removal– Cutting a fallen tree (That hasn’t hit the ground) into sections for removal. Being in a vertical position gravity and the tree that is hung are the controlling force’s.